Pulling up

[Blackfire]

Why are corners pulling up? Pei plate, glue stick, filament dried 12 hours prior. 65°C bed, 215°c nozzle.

[Blackfire]

#2

[Shadowcat]

I’m just posting here so I can get the notifications when someone responds to your question Josh.

[Shadowcat]

No recommendations or suggestions yet?

[Blackfire]

nope

[MrRolfe]

2 issues cause this. Either a draft in the room where your printing or your part is cooling to quickly. Adjust your fan speed settings in the slicer down. A cheater way to deal with it is print with a brim or mouse ear brim to help keep the corners down. Had this problem with the V3SE when I first got it and found that the cooling was the issue. As the part cools it pulls up on the lower layers causing your issue.

[Blackfire]

Good to know. It is on an Ender 5 V2, with enclosure, but when printing it is at top, so will try an over-all machine to cut out drafts completely.

[7000grain]

Agree with his comment on cooling.