Reloading

[Beowulf94E]

Does anyone here have questions about reloading i can maybe answer?

[Blackfire]

Differences in brasd prep methods.
QC and culling.
Depriming, swaging.
Flash hole uniforming.
FL sizing
Trimming processes, debur/chamfer
Annealing? To do or not to do...
Powder selection
Bullet selection
Primer selection
Diffrrences in presses
Differences in scales
Differences in trimmers
Powder drop variations.
Load tolerances
Seat/crimp
Post load cleaning.
Storage
Equipment maintenance

[Beowulf94E]

Wow thats a lot of questions. So let me try my best to answer these. Everyone has a Their own methods. I personally dont use a subsonic cleaner just because I don't have one. I take dirty range brass and separate then by size. I take the brass and begin to by tumbling them for a couple of hours in a media tumbler. Then I spray the lubricant on the brass and then deprime them. Then after depriming the I clean our and swagger the primer pocket ans clean that. From there I check the length of each piece of brass. Then I reinsert the proper primer... from there I go into and either stretch the brass or do what ever needs to be done... I don't know much about annealing so I can't comment on that... ( next one coming up soon)

[Blackfire]

No worries. You do just fine. Just suggestions.