Veterans Reloading

Why are corners pulling up? Pei plate, glue stick, filament dried 12 hours prior. 65°C bed, 215°c nozzle.

#2

I’m just posting here so I can get the notifications when someone responds to your question Josh.

No recommendations or suggestions yet?

nope

2 issues cause this. Either a draft in the room where your printing or your part is cooling to quickly. Adjust your fan speed settings in the slicer down. A cheater way to deal with it is print with a brim or mouse ear brim to help keep the corners down. Had this problem with the V3SE when I first got it and found that the cooling was the issue. As the part cools it pulls up on the lower layers causing your issue.

Good to know. It is on an Ender 5 V2, with enclosure, but when printing it is at top, so will try an over-all machine to cut out drafts completely.

Agree with his comment on cooling.